Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
guides:esxi_host_bootstrap [2019/05/14 02:03] aibekzhy [5. NICs] |
guides:esxi_host_bootstrap [2021/07/13 02:23] djmurray [3. First Boot] |
||
---|---|---|---|
Line 29: | Line 29: | ||
* Enter the correct information. See [this page](/cdr/networks/management) for detailed information | * Enter the correct information. See [this page](/cdr/networks/management) for detailed information | ||
* IPv4 Address: Check IP Ranges | * IPv4 Address: Check IP Ranges | ||
- | * Subnet Mask: 255.255.255.192 | + | * Subnet Mask: 255.255.255.128 |
- | * Default Gateway: 128.205.44.129 | + | * Default Gateway: 128.205.44.254 |
* Go to "IPv6 Configuration" | * Go to "IPv6 Configuration" | ||
* Disable it | * Disable it | ||
Line 52: | Line 52: | ||
* Username: root | * Username: root | ||
* Password: <the password you setup> | * Password: <the password you setup> | ||
- | * Enable Lockdown Mode | ||
* Press continue through everything else | * Press continue through everything else | ||
+ | * Enable Lockdown Mode | ||
+ | * Configuration -> Security Profile -> Lockdown Mode (Normal, not Strict) | ||
+ | |||
After a bit, the host should show up in the cluster you added it to. Woot! Now, setup the reset of the network connections, and datastore connections | After a bit, the host should show up in the cluster you added it to. Woot! Now, setup the reset of the network connections, and datastore connections | ||
Line 62: | Line 64: | ||
* Change name to "DO NOT USE - CSE Management Network" from "VM Network" | * Change name to "DO NOT USE - CSE Management Network" from "VM Network" | ||
* Enable vMotion for the port on that switch (This is located below "VMkernel Ports" Menu. | * Enable vMotion for the port on that switch (This is located below "VMkernel Ports" Menu. | ||
- | * Add a new NIC for [Direct IO](/cdr/networks/direct-io) | + | * Add a new NIC and vSwitch for [Direct IO](/cdr/networks/direct-io) |
* VMkernel Network Adapter | * VMkernel Network Adapter | ||
* New standard switch | * New standard switch | ||
+ | * Select appropriate adapter | ||
* Use the network label `direct-io` | * Use the network label `direct-io` | ||
* Use [static IPv4 settings](/cdr/networks/direct-io) | * Use [static IPv4 settings](/cdr/networks/direct-io) | ||
Line 87: | Line 90: | ||
* 10.0.0.155 | * 10.0.0.155 | ||
* 10.0.0.160 | * 10.0.0.160 | ||
+ | * Rescan the ISCSI Adapter | ||
===== 8. Host datastore ===== | ===== 8. Host datastore ===== |